To find if my lot is a zero line lot

The request was successful.

Dear Blacktown City Council,

I am going to buy a lot in Minchinbury.

Lot 5 in unregistered Deposited Plan 1250526 which was previously known as Lot 5
in Deposited Plan 456609, Great Western Highway, Minchinbury NSW 2770

Lot size is 9.45 by 32.

I want to know if this is a zero line lot or not. Can you please confirm before I go for 10% deposit on this lot.

Yours faithfully,
Kamran Zafar
0403721484

Brock Cauchi, Blacktown City Council

1 Attachment

Hi Zamran,

 

Development enquiry

 

I refer to your enquiry requesting information on setbacks in relation to
Lot 5 in unregistered Deposited Plan 1250526 (as determined in
DA-17-01083) currently known as Lot 5 in Deposited Plan 456609. In
response, please find below the following:

 

The subject appears to be zoned R2 Low Density Residential under Blacktown
Local Environmental Plan 2015. Blacktown Development Control Plan 2015
("DCP") applies.

 

You are referred the following sections of the DCP that apply:

 

Frontage requirements

·         The minimum frontage width frequirement is 12m. Please refer to
3.7 (Narrow frontage allotments) of the DCP for information on the
requirement to amalgamate lots less than 12m in order to achieve a
suitable frontage for residential development, and controls for
development over 2 lots on narrow frontage allotments should this be
pursued.

 

            Setbacks

·         3.2.4 Side and rear boundary wall setbacks (maximum 2 storeys)

o    The ground storey walls of any dwelling house or additional shall be
setback a minimum 900mm from any side or rear boundary of the allotment,
except where provisions of Section 3.2.3 apply

 

·         3.2.5 Side and rear boundary wall setbacks (more than 2 storeys)

o    The ground storey walls of any dwelling house or dwelling house
additional shall be setback a minimum 1.5m from any side or rear boundary
of the allotment

 

·         3.6.4 Side or boundary wall setbacks (for garages)

o    The wall of any detached garage, carport, awning or shed shall be
setback a minimum 500mm from any side or rear boundary of an allotment.

 

·         Eaves and gutters are to be located 675mm from the boundary in
accordance with the DCP.

 

I trust this information is of assistance.

Kind regards,

 

Brock Cauchi
Town Planner

9839 6000
[email address]
PO Box 63 Blacktown NSW 2148
[1]blacktown.nsw.gov.au

Follow us on social media

 

show quoted sections

References

Visible links
1. http://blacktown.nsw.gov.au/

Dear Blacktown City Council,

Please pass this on to the person who conducts Freedom of Information reviews.

I am writing to request an internal review of Blacktown City Council's handling of my FOI request 'To find if my lot is a zero line lot'.

The response I received did not answer my question which was specific to my lot.

A full history of my FOI request and all correspondence is available on the Internet at this address: https://www.righttoknow.org.au/request/t...

Yours faithfully,

Kamran Zafar

Blacktown Council, Blacktown City Council

1 Attachment

Council acknowledges receipt of your email and it has been forwarded to
the appropriate section(s) within Council. E-mails are managed as
correspondence. Council’s service standards are to reply to correspondence
within 10 working days. 

 

If your e-mail relates to an urgent service request please contact
Council’s customer service team on 9839 6000.

 

[1]cid:image002.png@01D542EE.241E1AA0

show quoted sections

References

Visible links

Brock Cauchi, Blacktown City Council

1 Attachment

Hi Kamran,

Please find attached.

Kind regards,

Brock Cauchi
Town Planner
9839 6000
[email address]
PO Box 63 Blacktown NSW 2148
blacktown.nsw.gov.au
Follow us on social media

show quoted sections